Does anyone go to the shops at 4 or 5 am?

Printable View

Show 25 post(s) from this thread on one page

24-09-2023, 09:28 PM
MrPB

Quote:

Originally Posted by GoldfishMan

RE the OP question, I wouldn't recommend going so late. I tried once going at around 4am. Roster showed clearly some girls were on at that time. It was the stupidest thing. This was the old 5*. Receptionist opened the door, already half asleep and rubbing his eyes. I asked something like "are you open / any girls on?". He said they were closed! I'm guessing it was too quiet, so they just shut shop earlier. WTF... I went home and jerked off.

Moral of the story, can't rely on the ultra late night / early morning rosters because they can just close up (even the girls might give up and go home) earlier than expected if there was no business.

I actually had a similar experience. Couldn't sleep one night so just got up and drove to the shop, must have been 2am when I got there. Roster showed at least 4 girls on, however I was only shown 2 girls and told that was all for selection. A bit disappointing, but I did the deed and was able to sleep much better after.
25-09-2023, 10:34 PM
earl9122

I never had experienced punting those ranges. might as well get some good sleep and return full of vigor
25-09-2023, 10:43 PM
bung72

5-6am I could handle.... I'd need that gorgeous WG in bed with me from the night before though.... then that is morning sex.... that's the best kind.... :) then go back to sleep, round 2 at 8!
25-09-2023, 11:09 PM
zacsuck

Quote:

Originally Posted by ditchtheboss

I was just checking the roster at 42G and I noticed that quite as few girls finish at 6am. I get punting around 1am but beyond that it must be awfully quiet.

There are 8 girls who finish working tomorrow between 4 and 6am.

Who goes punting around 4 or 5 am?

I have just returned from a few days working in Hong kong.
It was a very unexpected trip and my flight tickets were very last minute (done in the taxi to the airport !!).
I actually didn't even have time to sort out my accomodation before getting on the plane so I thought I would wing it as I have an idea in the back of my mind and I wondered if I could possibly do in Hong Kong/Kowloon what I have done recently in Tokyo.

Ok, normally in Tokyo I never know what time I am finishing and where I might be working on a particular day, so recently I have been using "Love Hotels" for overnights. Been working well when combined with Capsule hotels if I get stuck.
SO I arrive on HK (approx 6.30am) and proceed to Jordan where the urgent job it. I actually had it finished up completely by 6pm, so off for a walk to dinner and followed by temple street markets. Now wandering thru the markets and seeing the street workers gave me an idea so I bought a sim and got online. Yes using 141 site and checking spa's I found one which was midnight to 8 am, $5000 (HKD). about double a decent hotel , but a woman and facilities included.

Worked out very nice thank you. Yes 4 or 5 am I was probably pumping pussy :cool2:

Wish we had similar in Sydney !!
26-09-2023, 08:31 AM
GoldfishMan

Quote:

Originally Posted by zacsuck

I have just returned from a few days working in Hong kong.
It was a very unexpected trip and my flight tickets were very last minute (done in the taxi to the airport !!).
I actually didn't even have time to sort out my accomodation before getting on the plane so I thought I would wing it as I have an idea in the back of my mind and I wondered if I could possibly do in Hong Kong/Kowloon what I have done recently in Tokyo.

Ok, normally in Tokyo I never know what time I am finishing and where I might be working on a particular day, so recently I have been using "Love Hotels" for overnights. Been working well when combined with Capsule hotels if I get stuck.
SO I arrive on HK (approx 6.30am) and proceed to Jordan where the urgent job it. I actually had it finished up completely by 6pm, so off for a walk to dinner and followed by temple street markets. Now wandering thru the markets and seeing the street workers gave me an idea so I bought a sim and got online. Yes using 141 site and checking spa's I found one which was midnight to 8 am, $5000 (HKD). about double a decent hotel , but a woman and facilities included.

Worked out very nice thank you. Yes 4 or 5 am I was probably pumping pussy :cool2:

Wish we had similar in Sydney !!

Nice, thanks for sharing your story, bro. May I enquire, what is your line of work that you have to physically be there to complete the work?

EDIT: Not doubting your story, just really envious. I've always wanted a job that allowed me to travel to all these sex trade hotspots (especially Asian ones!). You get to be rewarded for work, and also reward yourself with lots of Asian pussies!
26-09-2023, 10:11 AM
ditchtheboss

Quote:

Originally Posted by GoldfishMan

Nice, thanks for sharing your story, bro. May I enquire, what is your line of work that you have to physically be there to complete the work?

EDIT: Not doubting your story, just really envious. I've always wanted a job that allowed me to travel to all these sex trade hotspots (especially Asian ones!). You get to be rewarded for work, and also reward yourself with lots of Asian pussies!

Same here, honestly curious. I am in unusual and rare specialty in my work that gets me to travel within Australia but that’s nowhere near as much fun as going to Asia. I am actually in Perth this week and I don’t think I will punt here at all
26-09-2023, 11:39 AM
zacsuck

Quote:

Originally Posted by ditchtheboss

Same here, honestly curious. I am in unusual and rare specialty in my work that gets me to travel within Australia but that’s nowhere near as much fun as going to Asia. I am actually in Perth this week and I don’t think I will punt here at all

I work in electronics.
I came up with a device many years ago and a large japanese company bought the rights years ago and I ended up working for them for close on 20 years in Tokyo.
The device is used 24/7 in equipment normally costing over $10million.usd.
the are installations only is SE.Asia and Oceania and N.America.
None in EU, S.America, Africa nor ME.
26-09-2023, 04:05 PM
GoldfishMan

Quote:

Originally Posted by zacsuck

I work in electronics.
I came up with a device many years ago and a large japanese company bought the rights years ago and I ended up working for them for close on 20 years in Tokyo.
The device is used 24/7 in equipment normally costing over $10million.usd.
the are installations only is SE.Asia and Oceania and N.America.
None in EU, S.America, Africa nor ME.

Wow... amazing. Please tell me you're raking it in. Mucho $$$ for that kind of thing, bro!
26-09-2023, 08:04 PM
earl9122

Quote:

Originally Posted by zacsuck

I work in electronics.
I came up with a device many years ago and a large japanese company bought the rights years ago and I ended up working for them for close on 20 years in Tokyo.
The device is used 24/7 in equipment normally costing over $10million.usd.
the are installations only is SE.Asia and Oceania and N.America.
None in EU, S.America, Africa nor ME.

That's quite an interesting journey you've had in the electronics industry, mate! It sounds like your invention found a valuable niche in the market, especially in SE Asia, Oceania, and N. America. The fact that it's used in high-value equipment is a testament to its significance and reliability.

It's also intriguing that the device hasn't made its way into the EU, S. America, Africa, or the Middle East yet. Expanding into new markets can be a strategic move for companies looking to grow, so perhaps there's untapped potential in those regions. However, market dynamics, regulations, and business strategies can vary widely from one place to another.

If you're still involved in the industry or interested in the device's further development and expansion, you might consider exploring opportunities to introduce it to new markets or industries. Innovation and adaptation can be key to long-term success in the world of electronics.
26-09-2023, 09:21 PM
zacsuck

Quote:

Originally Posted by earl9122

That's quite an interesting journey you've had in the electronics industry, mate! It sounds like your invention found a valuable niche in the market, especially in SE Asia, Oceania, and N. America. The fact that it's used in high-value equipment is a testament to its significance and reliability.

It's also intriguing that the device hasn't made its way into the EU, S. America, Africa, or the Middle East yet. Expanding into new markets can be a strategic move for companies looking to grow, so perhaps there's untapped potential in those regions. However, market dynamics, regulations, and business strategies can vary widely from one place to another.

If you're still involved in the industry or interested in the device's further development and expansion, you might consider exploring opportunities to introduce it to new markets or industries. Innovation and adaptation can be key to long-term success in the world of electronics.

I have rights of where the device can be used. all part of original agreement.
I have not changed my attitude since.
think about apple and their EU problems, and its a bit similar.
In reality I haven't had to work since sell main rights. the initial payment and then annual continuing is very comfortable existence.

I was very fortunate.
end of story.
26-09-2023, 10:10 PM
steelfreddy2

G'day, mate! Well, ya see, some massage shops might be open at 4 or 5 in the mornin', especially in the big cities or places where folks work around the clock. Aussies are a diverse bunch, and our schedules can be all over the place, so you never know when someone might need a good rubdown. Just remember to check the shop's hours and make sure it's a legit place, and always look out for your own safety, alright? Cheers!

Show 25 post(s) from this thread on one page